Concept Labdrivetrain bench
Assembly lab

Flywheel, gear ratio and generator load

Set the flywheel, the gear train and the generator, then sweep the ratio. Everything below is computed from the numbers in the left column, including the ones you replace with measured values. Gear ratio trades torque for speed; the return lives in where the generator sits on its efficiency curve, how much inertia you carry, and which losses you can starve.

Inputs

Flywheel

Gear train

Generator

Losses

Defaults are placeholders so the bench runs. Replace every field with your measured number and the answer becomes yours.

idle

Cycle, burst and generator bank

Stored energy is the reservoir. Burst factor is how many times the input power you can deliver while it drains. The bank splits torque; it does not multiply it.

Wheel600 rpm1200 rpm2400 rpmSpin-up at your input

Ratio sweep

RatioFlywheel rpmReturn %Stored kJRide sDrag W

What the bench is doing

Flywheel energy is 0.5 I w^2, so stored momentum rises with the square of speed while windage and bearing losses rise with it too. The train multiplies speed by the ratio, which divides torque by the same ratio, so a stage never makes power; it moves the generator to the speed where it is efficient. Reflected generator inertia at the flywheel is I_gen x ratio^2, which is why a tall ratio makes the generator feel heavy. Ride-through is the time the flywheel can hold the load while speed decays, from the energy difference between the two speeds.

Measured input beats modelled input: log your real generator's rpm against output watts at three loads and I will fit the curve into this bench so the sweep reflects your machine.

© 2026 Delta Ridge Technologies